User guide

10
User Guide
Note 1: Upon power up or detection of a new device on an output the port should read the EDID to see if
it is DVI connected and if so remove the audio automatically for proper compatibility. This way if the input
EDID is HDMI the HDMI will still work with ports that have DVI connected.
Note 2: If change is made from front panel the appropriate response command should be sent out. For
example if a route was made then the ~RTx1 x2 x3 x4 x5 x6 x7 x8<cr> should be sent automatically. This
way polling is not required.
Note 3: If an input has no HDCP then the output should not have HDCP either unless the force HDCP
command is enable.