User guide

14
User Guide
Click Save String Table to save the caption setting.
Click Set Default will pop up the confirmation message below for erasing the captions and
reset the string table to default setting.
2. Scan button
Serial Port Scan
Click Scan, the machine will scan the all com port
and show them.
Select the RS232 serial port connected to the
machine. And set device ID 255 is for all device.
Only the same device id or 255 can get the command
you sent.
Click OK to get the new status from the machine you
select.
3. Linkage button
Click Linkage to read back all status.
4. Open/Close button
Click Open or Close to open / close designated COM port.