User guide

7
User Guide
DESCRIPTION
Front Panel DXM G2 Series
LCD
Backlit display for the status and operation
0-9
Input / Output port selection number keys.
Switch
The HDMI signal toggle selection key. Example: 3→ Swi tc h →6→END→
ENTER to
switch signal from the input 3 to output 6 .
＆
Space key which is used to switch to many output ports at once.
Example: 1→Switch→2→＆→3→＆→6→END→ENTER to switch signal from the
input 1 to outputs 2, 3, 6 at the same time.
Al l
All command sends an input to every output at once or all inputs to each
output on a one to one
.
Example: 7→ALL means switching signal from input 7 to the all output ports.
Example: ALL→1 means all input ports to the all output one to one so that inp
ut 1
to output 1, input 2 to output 2 and so on.
Example: ALL→2 means turn off all I/O channels.
Save
The save key saves the I/O configuration into a memory preset
Example: SAVE→2 saves all I/O status into the NO.2 memory cell. “0～9” ten
presets in all.
Recall
The recall key will restore a saved memory preset.
Example: RECALL→2 restore the I/O status from the NO.2 memory preset.
Status
The status shows the matchup of inputs to outputs.
Cancel
The cancel key returns the DXM back to standby mode
Example: 1→Switch→2→END→CANCEL clears the input order and user can
type the new one if required.
END
The end key finishes a selection order.
ENTER
The enter key confirms a process selection.