User guide

16
User Guide
SERIAL COMMANDS
RS-232 Commands
NOTES:
! IS A COMMAND (Case sensitive)
? IS A QUERY COMMAND (Case sensitive)
~ IS A RESPONSE (All responses are in the same case as the command)
“<CR>” Represents a carriage return (Hexadecimal character 0x0D or Decimal 13‟)
Timing between commands – Wait at least 250ms between commands (version 2.1.8 and above)
Command
String Format
Information
Route Command
!Rxtoz<cr>
x = input port number = 0-32 (0 is to unroute)
z = output port number(s) = 1-32 For more than one port number
use a comma to separate. Example 1,4,5
Preset
Command
!Px<cr>
x = 1-9
Preset Save
Command
!Sx<cr>
x = 1-9
Baud Rate Setup
Input Command
!BRabINx<cr>
a = baud rate = 2400, 4800, 9600, 19200, 38400
b = bits, parity, stop = 8N1, 8E1, 8O1
x = port number(s) = 1-32 1-32 1-32 etc. More than one port #
use space between.
Baud Rate Setup
Output
Command
!BRabOUTx<cr>
a = baud rate = 2400, 4800, 9600, 19200, 38400
b = bits, parity, stop = 8N1, 8E1, 8O1
x = port number(s) = 1-32 1-32 1-32 etc. More than one port #
use space between.
Serial Input Card
Port Receive
!RXaINx<cr>
a = OFF or ON
x = port number(s) = 1-32 1-32 1-32 etc. More than one port #
use space between.
Note: To limit traffic on main RS-232 port turn off ports where the
feedback does not matter.
Serial Output
Card Port
Receive
!RXaOUTx<cr>
a = OFF or ON
x = port number(s) = 1-32 1-32 1-32 etc. More than one port #
use space between.
Note: To limit traffic on main RS-232 port turn off ports where the
feedback does not matter.