Specifications

Table Of Contents

Communications with SkyeTek Protocol v2

Using a SkyePlus MXH with a SkyeModule M1 49

Example: Enabling a Port

In the next example, the request data field (0x02) indicates that port 2 of the

multiplexer will be enabled.

(For Multiplexer system parameter)

Command = Write System Parameter

Mandatory Flags = (none)

Start Flag Command Starting Block Number of Blocks Data CRC End

Request: (ASCII mode):

Start Response CRC End

Response: (ASCII mode)

Example: Enabling a Port

In the following example, the system parameter location, or starting block, is

0x09. The Number of Blocks parameter is 0x01 or one block. The CRC Flag is set.

The Data field value sets the multiplexer port address (see Table 4-3 on page 48).

(For Multiplexer system parameter)

Command = Write System Parameter

Mandatory Flags = (none)

Start Message Length Flags Command Starting Block Number of Blocks Data CRC

<STX> 0x07 0x20 0x42 0x09 0x01 0x02 0xF555

Request: (Binary mode):

Start Message Length Response CRC

<STX> 0x03 0x42 0x4B7E

Response: (Binary mode):