Specifications

25
SkyePlus™ MXH and MXU Multiplexer Reference Guide
Copyright 2008 SkyeTek, Inc. All Rights Reserved.
Chapter 4
Software Configuration
Overview
The SkyeModule firmware gives the multiplexer full compatibility with the latest
host interface board for either the CF or MH versions of the SkyeModule readers.
Make sure that your SkyeTek reader has the correct version of the firmware
before you connect it to the SkyePlus multiplexer:
● For the M2: March 7, 2007 release, 0x010104BD or higher
● For the M9: May 14, 2007 release, 0x010001C3 or higher
● For the M7: all firmware releases
For information about how to check your firmware version, consult the reference
guide for your reader.
Lore m ipsum dolor s it ame t, c o n s e c tetuer
lobortis pulvinar magna. Morbi quis
fermentum. In sodales feugiat sem.
Sed ut p e d e . N a m tempus. Maecenas rutrum
Cur abitur nunc. Aenean sce lerisque
Suspendisse erat. Ma u r is ut cu
vestibulum sem. Vivamus et, v e l lectus vitae
Ut or ci risus, convallis et, S u s p e n d isse suscipit vulputate elit.
etra enim.
Suspendisse elementum. Sed enim lorem, suscipit quis, vestibulum
in, suscipit non, ante. Lorem ipsum dolor sit amet, c o n s e c tetue r
habitasse platea dictumst.
Suspendisse suscipit vulputate elit.
. S e d
consectetuer risus.
luctus imp e r d iet.
pre tium c ondime n tum.
Note – If your firmware does not support the host interface board, you can
connect your SkyeModule reader to the multiplexer via the CF or MH connector
(see
‘‘Hardware Configuration’’ on page 21). Or, if you have an older firmware
release and are using a Common Blade Interface Board (CBIB) to connect your
multiplexer to your reader, refer to
Appendix C, “Using SkyePlus Multiplexers
with a CBIB” on page 41.
The MUX Control system parameter for your SkyeModule reader lets you
configure and control your SkyePlus multiplexer. This section describes how to:
● Set the parameter’s default values to enable the multiplexer.
● Write values to the system parameter to control multiplexer behavior.
The MUX Control system parameter is a 1-byte value at address 0x0A.
● For more information about SkyeWare software, see the SkyeTek Developer
Kit User Guide.
● For more information about commands, see the SkyeTek Protocol v3 Reference
Guide.