Specifications

Firmware and Compatibility
10 SkyePlus™ MXH and MXU Multiplexer Reference Guide
Copyright 2008 SkyeTek, Inc. All Rights Reserved. Version 080715
● Both types of multiplexer connect to the SkyeModule reader via the
SkyeTek host interface board for power, control, and RF connections (see
“Hardware Configuration” on page 21).
● You can also create a custom interface for the SkyePlus multiplexer without
using the host interface board by running the multiplexer connections
through either the CF-style or MH-style connectors. (See
‘‘Connecting
Through the MH Module Connector’’ on page 23 or ‘‘Connecting Through
the CF Module Connector’’ on page 24.)
Firmware and Compatibility
The SkyeModule firmware gives the multiplexer full compatibility with the latest
host interface board for either the CF or MH versions of the SkyeModule readers.
Make sure that your SkyeTek reader has the correct version of the firmware
before you connect it to the SkyePlus multiplexer:
● For the M2: March 7, 2007 release, 0x010104BD or higher
● For the M9: May 14, 2007 release, 0x010001C3 or higher
● For the M7: all firmware releases
For information about how to check your firmware version, consult the reference
guide for your reader.
If you have an older firmware release and are using a Common Blade Interface
Board (CBIB) to connect your multiplexer to your reader, refer to
Appendix C,
“Using SkyePlus Multiplexers with a CBIB” on page 41.
Lore m ipsum dolor s it ame t, c o n s e c tetuer
lobortis pulvinar magna. Morbi quis
fermentum. In sodales feugiat sem.
Sed ut p e d e . N a m tempus. Maecenas rutrum
Cur abitur nunc. Aenean sce lerisque
Suspendisse erat. Ma u r is ut cu
vestibulum sem. Vivamus et, v e l lectus vitae
Ut or ci risus, convallis et, S u s p e n d isse suscipit vulputate elit.
etra enim.
Suspendisse elementum. Sed enim lorem, suscipit quis, vestibulum
in, suscipit non, ante. Lorem ipsum dolor sit amet, c o n s e c tetue r
habitasse platea dictumst.
Suspendisse suscipit vulputate elit.
. S e d
consectetuer risus.
luctus imp e r d iet.
pre tium c ondime n tum.
Note – If your firmware does not support the host interface board, you can
connect your SkyeModule reader to the multiplexer via the CF or MH
connectors. See ‘‘Hardware Configuration’’ on page 21 for more information.