User Manual

56
EN
Now playing information
While a FM station is playing, the screen shows one of the two following
sets data:
• If RDS information is available, by default the service name (i.e. station
name) is displayed. You can cycle through further RDS information
by pressing Info. Each time you press Info, another set of information
is displayed, cycling through RDS radio text, RDS programme type,
frequency and today’s date.
• If no RDS information is available, the currently tuned frequency is
shown.
Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan setting to
stop only at stations with good signal strength, select Menu > Scan setting
> Strong stations only? > Yes
Audio Settings
By default, all stereo stations are reproduced in stereo. For weak stations,
this may result in a poor signal-to-noise ratio (hiss). To play weak stations
in mono, select Menu > Audio setting > FM weak reception: Listen in mono
only > Yes.
CD
To enter CD mode, either press Mode to cycle through the listening modes
until CD is displayed, or select Menu > Main menu > CD. The CD menu
oers the following options:
• Shule (O /on)
• Repeat (O / Repeat one / Repeat folder / Repeat all)
• Main Menu
The display screen for the CD function will show “Loading…” followed by
“Reading “,“No Disc”.
Select the Open/Close CD function on the radio or the remote. Insert your
CD slightly and drive will take CD into the system to play.
The rst song on the CD will now begin to play, and show the playing time.
Press info button at remote repeatedly or OK button in the main unit, if
the format with ID3, it will show the info( Today’s date, File, Folder, Album,
Artist, Title).