User Manual

Table Of Contents

INITIAL USE

Before operation, please make sure that the VOLTAGE mentioned on the

power supply is same as the voltage of your local area.

Use the supplied mains adaptor to connect the device to a household mains

socket.

When it is the rst time running the device, the setup wizard is launched

automatically.

Press Standby button when unit is power on, unit will go to standby mode.

Press again will make it on again.

Setup wizard

When radio is started for the rst time, it runs through a setup wizard to

congure settings for date/time and network. Once this has nished, the

system is ready to use in most modes.

Note: To change these settings later, select Menu>System settings>and

select the required settings options. To run the setup wizard again, select

Menu>System settings>Setup wizard

The Setup wizard guides you through the basic setup parameters for Time/

Date and Network connection. To change any settings later all setting

functions are accessible from the Settings Menu.

OPERATION

After the initial setup, radio is ready for operating in most Modes.

Mode selection

From the Main Menu select a mode and press OK. Alternatively press Mode

button repeatedly to switch to dierent mode. After a brief moment radio

switches to that mode. The last station or track previously used in that

mode is selected. If this is not possible, radio scans for relevant stations,

networks, or prompts the user for appropriate input.

Audio playback

The common local controls for audio playback are available in all listening

modes:

The general track controls are Play/Pause to start and stop tracks and

the Next and Previous buttons to skip to the next or previous track in the

current playlist.