User manual

English
5.10.1 Set the Alarm Clock
1. Press & hold the SNOOZE/DIM button until “Alarm 1 Setup” displays on the
LCD screen, to set alarm 2, press and hold the SNOOZE/DIM button again until
“Alarm 2 Setup” displays.
2. Press OK button to start the Alarm 1 Wizard, the alarm wizard prompts you for
the following information: Select a value for each parameter in turn by using “>”
or “<” button and then press OK to confirm and move on to the next parameter:
3. Select your desired settings in turn using the “>” or “<” and the OK button. After
selecting Off or On, the alarm will be saved.
On time
Duration – 15 | 30 | 45 | 60 | 90 minutes. The alarm will automatically stop
after the selected time.
Source – DAB | FM | Buzzer, If DAB or FM is chosen as the audio source you
will also be prompted to select the last played station or one of the preset
stations.
Daily / Once / Weekends / Weekdays, set the repeat mode. If Once is
selected, you will be asked to set the date of this alarm.
Alarm – Off | On
– hours and minutes
Note: When the alarm sounds, it begins quietly and gradually increases in volume
up to the current volume of the radio. To stop the alarm, press and hold the
SNOOZE/DIM or Standby button.
Note: The alarm can be set only when the clock time has been set. The clock time
can be set by DAB signal. Or you can manually set the clock time, see 5.8.
5.10.2 Snooze
When the alarm sounds, press the SNOOZE/DIM button to snooze the alarm for 10
minutes. During the snooze period, the alarm bell icon on the LCD will flash.
6. Specifications
Bluetooth version
3.0+EDR
Bluetooth profile
Bluetooth working range
DAB radio frequency
FM radio frequency
Speaker
Power adaptor
Batteries
USB port
SD card reader
Standby Power Consumption
Power Consumption
Dimensions
Net weight
A2DP
up to 10m
174.928-239.2MHz
87.5-108MHz
2 x 3W RMS
Input AC 100-240V~50/60Hz; Output DC 5V 1 5A.
4 x C batteries
Supports USB memory stick in FAT format and up to 16GB
Supports SD/MMC card up to 16GB
<1W
8W
205 x 73 x 155 mm
0.72 kg
7. Troubleshooting
The device has no power
Check that your batteries are not drained, that they are inserted correctly, that
the contact pins are clean.
Your adapter connection may be loose. Connect it securely.
The sound quality is intermittent in Bluetooth mode
Please ensure the headset is within 10 metres of your source device.
Please disable the Wi-Fi on your source device.
The indication "Service not available" is displayed in DAB mode
The DAB signal may be too weak play the program. Please fully expand the
antenna or adjust the position of the radio.
You may have moved to a new area which gets the station is different
frequency. Autoscan your DAB radio and refresh the list of stations in service
(see chapter 5.3.1 Auto Scan).
The station is out of service.
-11-
-12-