User manual

English
5.4.3 Prune
The Prune function can be used to remove any stations that are saved to your DAB
radio list but not available. This function will remove all stations that are listed
with a “?” in front of the station name.
1. Press Menu then use “>” and OK to select Prune from the submenu
2. Press “>” to select “Yes” and then press OK button to confirm.
5.4.4 Station Presets
The unit allows you to store up to 20 DAB stations for quick tuning.
5.4.4.1 Save a station
1. Whilst the station you would like to save is playing, press and hold the PRESET
button until the Preset Store displays on the LCD.
2. Press “<” or “>”to choose the preset memory position then press OK to confirm.
5.4.4.2 Recall a station
1. Press PRESET whilst in DAB mode to open the list of preset stations.
2. Press “>” or “<” button to select the preset station.
3. Press OK to confirm.
5.4.5 Station Information
To access additional information broadcast by a DAB radio station, press INFO, this
will cycle through all the DLS (Dynamic Label Segment) being broadcast.
Pressing INFO cycles through DLS text, DL Plus information (this is only displayed if
broadcast by the station), signal strength, program type, ensemble name, channel
number/frequency, signal error rate, bit rate, codec/DAB variant, time and date.
Note: DL Plus presents additional information that can be broadcast by stations and
stored temporarily on your radio.
Press and hold the INFO button to return to the Now Playing screen.
5.4.6 Dynamic range compression (DRC)
DRC balances the differences in volume between the loudest and quietest audio
being broadcast. This can reduce the need to adjust volume when the sound being
broadcast changes volume.
Note: DRC is managed by the broadcaster and may not be utilised by all stations.
5.4.6.1 Change the DRC Setting
1. Press Menu then use “>” and OK to select DRC from the submenu
2. Press “>” or “<” to select the available options: DRC off, DRC high, DRC low.
DRC off: DRC is switched off
DRC high: DRC is switched on (default setting)
DRC low: DRC is set to 50%
3. Press M to return to Now Playing screen.
5.5 FM Mode
FM radio mode allows you to listen to FM broadcasting (87.5-108MHz) and view
RDS (Radio Data System) information.
5.5.1 Scan
1. Fully extend the aerial wire.
2. Press the Standby button to exit standby mode.
3. Press the M button to select FM mode.
4. Press the SCAN button or press and hold the “<” or “>” button to scan for a
station, the radio will tune to the next station found.
5. Press “<” or “>” button to tune the radio up or down in 50 KHz steps for
fine tuning.
6. To improve radio reception, you can reposition the aerial or radio if necessary.
-7-
-8-