User manual

-19-
12. Specifications
LCD Display
DVB-T Decode Standard
MHEG2
DVB-T Band Width
6, 7 ,8
DVB-T Frequency
VHF: 174~230 MHz
UHF: 470~862 MHz
Antenna Input
Impedance: 75ohm
Card Reader
Support SD/MMC card up to 8GB
USB Port
USB 2.0 host (5v 800 ),Am
Built-in Speaker
2 x1W, 8 ohm
Power Adaptor
AC 100~240V 50~60 Hz
DC 12V/1.5A
Power consumption
7.5W
Dimensions
242x182x10.7mm
Net Weight
670g
Screen size: 8 Inch
Resolution: 800X600 pixels
Aspect Ratio: 4:3
Brightness: 250 cd/m
Contrast: 150:1
2
Media Formats
File Type
Video Type
Audio Type
Audio bit Ratio
Resolution
Frame Rate
Caption
File Type
Bit Ratio
File Type
Resolution
AVI,MPG,ASF,VOB
MPEG1, MPEG2, MPEG4
MPEG1/2, Layer 1/2/3, PCM, LPCM
32Kbps ~ 320Kbps
Max. 720 x 480
Max. 30fps/25fps(PAL)
DIVX(4.0, 5.0), XVID
MP3,WMA
32Kbps~320Kbps
JPG,JPEG(not include non--interlace)
Up to 4000 x 3000 pixels
Video player
Music player
Photo viewer
Problems listed below do not necessarily signify a fault with the unit.
Please check this list before requesting repairs.
13. Troubleshooting
Problems
No picture and no sound
Check the connection with the AC adaptor.
Use of an unauthorized power supply.
Switch the power button on the side of the device to ON.
Check the channel selection. Scan for channels again.
Always rescan for channels in new locations.
Check the sound volume. If you are using earphones, test
them on another item. Check the earphone cable is plugged
into the earphone socket on the device.
Possible Causes and Solutions
Picture freezing, and/or
sound distorting
Signal too weak, please check the aerial. Try to use a
proper roof top aerial or an amplified aerial.
No signal
Signal too weak, please check the aerial. Try to use a
proper roof top aerial or an amplified aerial.
Please adjust Brightness and/or Contrast settings.
Dark Picture
Motors/Trains/High Voltage Lines and Neon Lights may
affect the signal.
Snowstorm
Achromatic/Flashing/No Colour
Please adjust the Colour Setting.
No sound
No image
No user serviceable components are fitted inside this TV. Do not attempt
any repairs, as this will invalidate the warranty. Any repairs must be carried
out by either the manufacturer or their nominated service centre. Parts
inside this set are subject to high voltage.
-20-