Installation & Assembly

ManualsBrandsAugust Grove ManualsDining Tables & SeatingVallelunga Slat Back Side Chair

Caution: You must read this before you proceed.

SPINDLE BACK CHAIR

WARNING: These chairs are intended only for normal use with all four chair legs on the ground.

These consumer chairs have relatively thin legs and are not designed to be sat in with only two

chair legs on the ground (as from tipping back, forward, or to the side), and such can cause stress

and failure of one or more chair legs. Any misuse of the chairs voids any warranties, express or

implied.

Noble House Home Furnishings LLC

Page 1 OF 7

Summary of content (7 pages)

PAGE 1
Caution: You must read this before you proceed. SPINDLE BACK CHAIR WARNING: These chairs are intended only for normal use with all four chair legs on the ground. These consumer chairs have relatively thin legs and are not designed to be sat in with only two chair legs on the ground (as from tipping back, forward, or to the side), and such can cause stress and failure of one or more chair legs. Any misuse of the chairs voids any warranties, express or implied.
PAGE 2
Part NO.
PAGE 3
Before Beginning Assembly: Parts Introduction This Spindle Back Chair has multiple parts and may require up to 20 minutes to assemble. To give you an overview of the Chair parts, the above picture is to help you put the various Chair parts into perspective. Please read through the instructions herebelow to familiarise yourself with the parts and steps before assembly.
PAGE 4
Step 1 A. Chair/Seat B. Right Leg Frame C. Left Leg Frame D. Middle Support Rail Place the Chair/Seat(A) on a clean, non-marring surface. take out all of the Parts and Hardware. Step 2 Insert Barrel Nut(F) into the holes on Middle Support Rail(D),and use Screwdriver(L) to adjust the Barrel Nut(F) mounting position. Attach the Left Leg Frame(B) to Middle Support Rail(D) by inserting JCBC Bolt(E) into Barrel Nut(F) with Allen Key(H) as showed in above.
PAGE 5
Step 3 Position the Leg Frame onto the bottom of Chair Seat(A). Align and attach Chair Back(A) and Leg Frame using Screws(G) with Screwdriver(L). Proceed to tighten all the bolts Note: Front Legs must be facing the front. Step 4 Adhere the Foam Pad(K) under the Legs.
PAGE 6
Step 5 Stand the Spindle Back Chair rightside up. Insert the wood button(G) into the leg support raill screw Hole Your Spindle Back Chair is ready for use.
PAGE 7
Noble House Home Furnishings LLC Page 7 OF 7