Owner Manual

Product Name:
Resin Rustic Cascading Pots Outdoor Fountain
Instruction Manual
SAVE THESE INSTRUCTIONS–This manual contains important
safety and operating instructions for power units.
Thank you for purchasing this product. This product has been manufactured with the highest standards of
safety and quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Quantity
Fountain
1
Pot
1
Pump 1
C
ompatible Pumps for this fountain:
Pump Model No.
JR450/LED
JB450/LED
YH707/LED
YH-LV110T
Tools required for assembly: No tools required for assembly.
Asse
mbly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. Insert the Pot into the fountain opening at the top.
4. From the opening at the back of the fountain base, insert the water supply tube into the pump outlet. Insert
the LED connector into the pump connector, and twist to tighten. Place the pump upright in the basin and
draw the pump power cord out of the fountain back.
5. Make sure the water tube is properly connected with the pump, and is not crimped.
6. Add clean water into the basin. The water level should be approximately 30mm lower than the edge of th
e
b
asin.
7. Connect the power cable to outlet. If installed properly, water flow in the fountain will begin shortly.
8. Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
9. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing