User Manual

DEVICE MAINTENANCE

1. Please clean the rubber lens holder with an alcohol wipe before every use and

allow it to dry completely before placing a lens on it. The lens holder should be

replaced at leas once every 3 months.

2. Immediately after inserting your lenses, take a moment to remove any liquid

that may have spilled onto your device. This will help prevent water from

getting into the electronic components of your device.

3. It’s important to make sure that the storage case for your device is completely

dry before storing the device in it. If you place containers in the storage case that

hold liquids (ex. contact lens cases), please ensure that they are securely closed

to prevent liquid damage to your device.

a. It’s recommended that you use an alcohol wipe to clean the outside of the

device as well as the storage case at least once per week. After cleaning,

make sure that all parts are completely dry before storing them.

4. The bottom of the suction base should be cleaned periodically with an alcohol

wipe to ensure maximum suction.

5. Charging the light unit:

a. When you notice the light becoming dim, it’s time to charge the light unit.

i. Disconnect the light unit from the base lever by twisting the

bottom half of the light unit (shown in green) counterclockwise.