User Manual

i. Connect the female end of the provided USB extension cable to the

bottom of the light unit.

ii. Connect the male end of the cable to a desktop or laptop

computer.

b. The light unit will reach a full charge after 1 hour of being plugged in.

INSTRUCTIONS FOR USE

BEFORE LENS INSERTION

1. Place the suction base on a smooth, flat surface. Ensure that both the bottom of

the suction base and the surface are clean and dry.

2. Hold down the outer edge of the suction base while pulling metal telescoping

arm upward until it locks into place in the vertical position. This will engage the

suction of the base.

3. Once the telescoping arm is in the vertical position, slide the base of the arm

forward for increased stability (see picture below).