User Manual

AFTER LENS INSERTION

1. Remove the rubber lens holder from the light unit.

2. Keep the light unit connected to the telescoping arm and dry off the outside

of the light unit with a paper towel.

3. Disassemble the device:

a. Disconnect the light unit from the telescoping arm.

4. Additional drying for the light unit:

a. Turn the light unit upside down to get rid of any liquid that has built up

inside the orange lens holder dock.

b. If you see liquid on or near the USB port of the light unit, soak it up

with a paper towel or a q-tip. If there is no liquid on the USB port, then

please avoid touching it.

5. Detach the base:

a. Collapse the telescoping arm down to its shortest height.

Please carefully follow the instructions below to keep liquid away

from the electronics of your device. Following these instructions will

extend the operational life of your device.