Tus neeg siv phau ntawv

8 ©2022 Augmented Vision Labs, LLC
7. Wash your hands with soap for 20 seconds and dry them with a lint-free towel.
8. Clean the rubber lens holder with a disinfecting alcohol wipe.
a. *Allow the lens holder to dry completely before placing your contact lens
on it.
9. Clean the upper segment of the light unit (the part that twists) with a disinfecting
alcohol wipe.
a. You can use the same wipe that you previously used to clean the lens
holder.
10. Inspect your lens to make sure it is clean and free of damage then place it on the
rubber lens holder.
a. It’s recommended to rinse your lens with preservative free saline if it was
previously stored in a multi-purpose cleaning solution.
11. Fill the lens bowl with a preservative-free saline solution that is approved by
your doctor.
a. Add saline until the level rises above the edge of the lens.
12. Twist the top half of the light unit counterclockwise to activate the light.