Tus neeg siv phau ntawv

11 ©2022 Augmented Vision Labs, LLC
7. Cover one eye at a time to see if you can notice any air bubbles that may be
trapped under the lens. It may be helpful to use a mirror and a flashlight to check
for air bubbles.
a. If air bubbles are seen, you must remove the lens and re-insert it.
AFTER LENS INSERTION
1. Remove the rubber lens holder from the light unit.
2. Keep the light unit connected to the telescoping arm and dry off the outside
of the light unit with a paper towel.
3. Disassemble the device:
a. Disconnect the light unit from the telescoping arm.
4. Additional drying for the light unit:
a. Turn the light unit upside down to get rid of any liquid that has built up
inside the orange lens holder dock.
Please carefully follow the instructions below to keep liquid away
from the electronics of your device. Following these instructions will
extend the operational life of your device.