Technical data

COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11 525
Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring the External PIN
1. Open the page SERVICE > Remote configuration.
2. Enter the external PIN in the External PIN entry field under Remote configuration
(PPP) and remote programming. The following entries are possible:
Note:
The PIN may not begin with a zero.
All of the PINs in the PBX are unique. This means that it is not possible to
allocate the same PIN twice.
Do not use dates of birth or dates as PINs. This makes it easy for an attacker
to find out the correct PIN. PINs which are easy to guess, such as 111111
or 123456, should also be avoided.
Further steps:
– Save your settings before you leave the page.
Changing a PIN Using an Internal Telephone
Requirements:
– Authorization Controlling of the PBX via telephone assigned to the subscriber
– Configured external PIN
– Knowledge of the external PIN
1. Pick up the receiver.
2. Dial *99*.
3. Enter the existing external PIN.
4. Dial *.
5. Enter the new external PIN. The following entries are possible:
Exactly 6 digits
Digits
Exactly 6 digits
Digits