Technical data

COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11 493
Service and Maintenance
Status Displays
Status Displays on the LEDs
Note: If the "Power" LED remains constantly lit even after a restart, an error
has occurred. Please contact your dealer or the manufacturer directly.
"LAN" LED: Status of the Ethernet interface (COMpact 3000 VoIP with
two Ethernet ports LAN):
Off No Ethernet connection to a computer/network exists.
Lit in green An Ethernet connection to a computer/network exists.
(COMpact 3000 VoIP: there is a connection on at least one
port).
Flashes green An Ethernet connection exists and packets are being trans-
mitted (COMpact 3000 VoIP: packets are being transmitted on
at least one port).
"Power" LED: PBX status (after restart):
Lit in red The boot partition is being tested.
Lit in orange The hardware data and the kernel are being loaded from the
partition.
Flashes orange The kernel drivers are being loaded.
Lit in orange The PBX application is being started.
Lit in green The PBX is ready for operation.
"Power" LED: Status on the PBX (in the case of an error):
Off No power supply is present.
Flashes red (1/1 s) No valid boot partition was found. System is paused.
"Power" LED: Menu prompt (after pressing the "Default" button):
Flashes red quickly (50/
50 ms)
Pressing the "Default" button is detected.
Flashes red slowly (0.5/
0.5 s)
The "Default" button was pressed for more than 5 seconds.
Releasing the button starts the update image.
Flashes red (0.05/1 s) The "Default" button was pressed for more than 10 seconds;
releasing the button restores the factory settings.
Lit in red The "Default" button was pressed for more than 15 seconds; the
PBX restarts without changes.