Technical data

COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11 461
Configuring and Managing the PBX
PBX Time
Switching Automatic PBX Time Updates via ISDN for Missing Time On/Off
Note:
The network provider usually transmits a time that is precise to the minute.
The time is updated at most once per hour.
Switching this on/off can be done as follows:
• Via the configuration manager
Requirements:
– External S
0
port (only COMpact 3000 ISDN or COMpact ISDN module available as an
option)
– Configuration manager, opened with sufficient authorization
1. Open the page CONFIGURATION > PBX time.
2. Select or clear the After each ISDN call check box.
Further steps:
– Save your settings before you leave the page.
Switching Automatic PBX Time Updates via ISDN for Missing Time On/Off
If updating the PBX time for missing time is enabled, the PBX automatically initiates an ISDN
call using the connection configured.
Note:
The automatic call is initiated if a valid time or a valid date is missing in both
the PBX and in the connected system telephone.
During an outgoing external call, the network provider usually transmits a
time that is precise to the minute that is then used to set the PBX time.
Switching this on/off can be done as follows:
• Via the configuration manager
Enables automatic updating of the PBX time after each ISDN call.
Disables automatic updating of the PBX time after each ISDN call.