Technical data

COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11 443
Configuring and Managing the PBX
DECT System Telephones
Copying a Function Key Assignment into Other Mobile Handsets
Copying can be carried out as follows:
• Via the configuration manager
Requirements:
– Internal S
0
port (only provided on the COMpact S
0
module or COMpact ISDN module
available as an option)
– Configuration manager, opened with sufficient authorization
– Configured internal telephone numbers for the base station
– Assigned internal telephone numbers for the mobile handsets
1. Open the page CONFIGURATION > Internal numbers > ISDN subscribers.
2. Click DECT settings.
3. Open the page Copy COMfortel DECT 900.
4. In the list field at the top, select the mobile handset, whose function key assignment
should be copied based on its name/number.
5. Select or clear the corresponding Copy function check box under Copy function
key.
6. Under Destination, select or clear the check box next to the internal telephone
numbers for the mobile handsets into which the selected function key assignments
should be copied.
7. Click Copy.
Note: The PBX begins to distribute the data to the mobile handsets in
question. If a mobile handset is currently not ready for the data transfer
(disabled, out of range or busy with a call), the PBX makes an attempt with
the next mobile handset after a few minutes until all of the data is distributed.
During the data transfer (duration: up to two minutes), the mobile handset is
not available and "Copying from PBX" is shown on the display.
Selects the assignment for copying.
Does not select the assignment for copying.
Enables the mobile handset as the destination.
Disables the mobile handset as the destination.