Technical data

COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11 433
Configuring and Managing the PBX
VoIP
Entering Telephone Numbers for the VoIP Point-to-Point Connection
A page opens for configuring the VoIP connection.
3. Open the page VoIP connection > Telephone numbers.
Note: The entry is also provided during the quick configuration using the
configuration wizard.
4. In the list field at the top, select the account in question by its name.
5. In the PBX base number entry field, enter the PBX base number (serial, head, basis
telephone number) with local area code (local dialling code) that, according to the
VoIP provider, belongs to the VoIP account.
Note: The country prefix is entered for the location (CONFIGURATION >
External numbers > Location). If the account provided by the VoIP provider
requires another country prefix, this number must be entered together with
the local area code preceding the PBX base number entered.
6. In the From entry field under Direct dialling in (DDI), enter the digit sequence you
received from your VoIP provider. The following entries are possible:
7. In the Name entry field, enter a display name for the telephone number. The following
entries are possible:
Note:
The name is used for display purposes on the system telephone.
If no display name has been entered, the account name is displayed.
When using the provider T-Online, the VoIP phone numbers obtained from
the provider must also be entered under Name.
8. Click .
9. Repeat Steps 3 to 6 to enter additional telephone numbers.
Up to 20 digits
Digits
Up to 4 digits
Digits
Up to 16 digits
Digits and characters