Technical data

350 COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
Configuring and Managing the PBX
Internal Telephone Numbers
Creating Analog Subscribers
Requirements:
– Configuration manager, opened with sufficient authorization
1. Open the page CONFIGURATION > Internal numbers > Analog subscribers.
The pre-configured analog subscribers are displayed.
Note: The creation is also provided during the quick configuration using the
configuration wizard.
2. If necessary, change one of the internal telephone numbers displayed or enter a new
internal number in the From entry field under Telephone numbers. The following
entries are possible:
Note:
Double allocation of a number is not possible.
The telephone numbers 70, 80, 87, 701-706, 801-806, 875-879 and 8750-
8799 cannot be freely allocated. They are required for internal PBX use.
Using telephone numbers with few digits (two or three-digit numbers) inevi-
tably restricts the possible supply of telephone numbers with more digits.
For example, if the telephone number 12 is assigned, the telephone
numbers 120-129 and 1200-1299 are no longer available.
The default exchange line access number on the PBX is "0" in the factory
settings; however, this can be changed. Note that changing the exchange
line access number restricts the telephone number plan.
3. Enter a name for identification purposes in the Name entry field. The following entries
are possible:
Note: The name is used for display purposes on the system telephone.
Furthermore, on some pages in the configuration manager (e.g., call data
list), the name is displayed in addition to the telephone number.
4. Select one of the following options from the Device type list field depending on the
device connected.
2 to 4 digits in the range of 10 to 9999
Up to 16 digits
Digits and characters