Technical data

COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11 203
Configuring and Operating Functions
Call Forwarding
Configuring the Use of the Feature via the PBX or the Network Provider
Switching this on/off can be done as follows:
• Separately for subscribers
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
Authorizations.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the Configuring features on the exchange line (e.g., MSN/DDI-CF)
check box.
Further steps:
– Save your settings before you leave the page.
Configuring the Use of the Feature via the PBX or the Network Provider
Call forwarding for external numbers can be configured via the PBX or via the network provider.
If the feature has been enabled for use via the PBX, an existing available voice channel is used
in order to forward the call. The charges for this additional connection established by the PBX
are billed to the PBX operator.
If the feature has been enabled for use via the network provider, call forwarding is carried out
by the central office. This prevents multiple numbers from being sent though call channels when
the system's own external telephone numbers are forwarded.
Note: However, the time necessary to set up the user telephone remains the
same. A longer configuration time (time until the acknowledgment) must be
taken into account.
The configuration can be made as follows:
• Via the configuration manager
Enables the authorization for configuring features on the exchange line.
Disables the authorization for configuring features on the exchange line.