Technical data

COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11 199
Configuring and Operating Functions
Call Forwarding
Switching Call Forwarding for External Numbers On/Off
2. Depending on the type of call forwarding desired, select or clear the one of the
following check boxes immediately or on busy or on no reply.
3. Enter the destination number in the Destination number entry field under the desired
type of call forwarding immediately, or on busy, or on no reply. The following entries
are possible:
Further steps:
– Save your settings before you leave the page.
Switching Call Forwarding Unconditional for External Numbers On/Off via an Internal
Telephone
Requirements:
– External analog port (only COMpact 3000 analog), external S
0
port (only
COMpact 3000 ISDN or COMpact ISDN module available as an option) or external VoIP
channel
– Authorization Controlling of the PBX via telephone assigned to the subscriber
– Subscriber authorization for configuring features on the exchange line
1. Pick up the receiver.
2. Dial ##96.
3. Enter the telephone number to be rerouted. The following entries are possible:
Note:
Telephone numbers to be rerouted are telephone numbers dialled by
external callers (prefix + PBX base number + DDI or prefix + MSN).
If the PBX only has one external connection and one telephone number has
been selected for number presentation, you can simplify call forwarding
configuration. If you configure call forwarding for external numbers for this
Enables the type of call forwarding in question.
Disables the type of call forwarding in question. (No other action is required.)
Up to 20 digits
Exchange line access number + external phone number
Short-code numbers
External phone numbers (independent of the configuration of the direct
exchange access)