Technical data

Table Of Contents

142 COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11

Managing the Telephone Book and Lists

Call Data

Configuring the Billing Factor

The billing factor indicates the value used to convert the subscriber's telephone costs.

This factor is used to multiply the charges transmitted from the network provider or the calcu-

lated charges. The telephone costs calculated in this way are used in the call data list.

The configuration can be made as follows:

• Separately for subscribers

• Via the configuration manager

Requirements:

– Configuration manager, opened with sufficient authorization

– Expert view (click )

1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >

Exchange line settings.

2. In the list field at the top, select the subscriber in question by his name or number.

3. Enter a value in the Billing factor entry field. The following entries are possible:

Further steps:

– Save your settings before you leave the page.

Switching Charge Information On/Off

If the charge information is enabled, the charge information transmitted by the network provider

is recorded by the PBX and can be evaluated for the individual calls.

Deactivating this function is only advisable if it causes problems on the external connection (this

depends on the network provider/country).

Factor in 0.00 format

Digits and separator "," (comma)

0.01 to 0.99: Reduces the telephone costs for the subscriber

1.00: The charges accrued correspond to the telephone costs of the subscriber

1.01 to 9.99: Increases the telephone costs for the subscriber