Technical data

Connect Devices to the Door/Switching Module 27
Connect Devices to the Door/Switching Module
The COMpact TS module does not belong to the supply of extent. The
COMpact 2206 USB has 1 module slot (B) for this module. The
COMpact 4410 USB has 2 corresponding module slots (B and C).
Thanks to the module you can connect or control one door terminal,
each consists of a door handsfree system, a door opener and two door
keys. Herewith the door ringing to all internal subscribers will be possi-
ble as well as the door conversation and door opening.
In order to execute different switching and controlling processes, the
module has a total of three relays that have to be configured corre-
spondingly to the special purpose. Two of these relays are preconfig-
ured for controlling the door terminal. If no door terminal is to be control-
led, these relays can be reconfigured for other uses.
If you use the module slot B, the relays are numbered consecutively
from 1 to 3 in the configuration. If you use the module slot C (only
COMpact 4410 USB
), the relays are numbered consecutively from 4 to
6.
In case that not both door key inputs are necessary in connection with
a door terminal, the inputs can be reconfigured to alarm contacts.
The three Light-Emitting Diodes on the module circuit board display the
activation status of the three relays.
LED switched on:Relay is switched on
LED switched off:Relay is switched off
To install a module, insert it in between the board rails and press it to
vertically the mainboard until clicks well into its position. (Pic. 28).
Disconnect the device from the 230 Volt power supply and
wait another 10 seconds before you plug a module in or
remove it.
As some of the component parts are sensitive to electrostatic dis-
charge, it is important to discharge yourself before touching the
mainboard with your hands or with tools. You should touch a
grounded metal device, such as a radiator or the case of a PC.
Advice for COMpact 4410 USB: Use a COMpact-TS Module
for door functions in slot B. The Announcement/Music on
Hold function will not be available if you use a COMpact TS
Module in slot C.
Description and Installation of the COMpact TS Module
e
☞
Pic. 27: Door/Switching module
햲 LED for indicating the on/off mode of the relay no. 3/6 (REL).
햳 LED for indicating the on/off mode of the relay no. 1/4 (TS).
햴 LED for indicating the on/off mode of the relay no. 2/5 (TO).
햵 Inputs for connecting the door keys 1 and 2 (also usable as
alarm contact).
햶 Make/Break contact of relay no. 3/6 (REL).
햷 Make contact of relay no. 1/4 for supplying the door handsfree
system (TS).
햸 Make contact of relay no. 2/5 for supplying the door opener (TO).
햹 Output of the 12 Volt operation voltage.
햺 In/Output of NF voltage against TGND.
햻 Plug for attachment to the mainboard.
햲 햳 햴
햵 햶 햷 햸
햻
햹 햺
Pic. 28: Insert COMpact TS module