Technical data

Commissioning
14
This section describes the commissioning of the system telephone as well as the commis-
sioning of the answering machine on the system telephone using a commercially-available
USB memory stick. Once you have finished commissioning the equipment, you will be able
to use the telephone immediately. You can easily customize your telephone and the answer-
ing machine using the computer configuration described at the end of this section.
Commissioning the Telephone
Note: If you would like to integrate the system telephone into an existing
network, please contact the system administrator responsible for this. Mak-
ing changes to an existing network may cause considerable malfunctions.
Requirements
– PBX, switched on (connected to 230 V mains)
– The PBX with at least the following firmware version:

3.0 or higher
Note: If you have devices with older versions, carry out the corresponding
device updates (see PBX manual).
– The internal telephone number for the system telephone configured on the
PBX
– Recommended: The user PIN of the internal telephone number entered in
the PBX configuration
Steps to Take
1. Open the plastic flap above the Ethernet port which is located on the back
of the system telephone (see Fig. 4 on page 15).
2. Insert one end of the RJ-45 cable included in the package into the left Eth-
ernet port on the system telephone (see Fig. 4 on page 15).
3. Insert the other end of the RJ-45 cable included in the package into an out-
put socket on the DSL router or into an existing network outlet.
4. If you need a power plug (type no. HW 824 or FW7577/EU/40), insert it into
a freely accessible 230 V power socket.
The display will show the menu for language selection.
5. Press the softkey in front of the desired language.
Use the softkeys (keys next to the display) to scroll through any list
to the selection you want.
Commissioning