User guide

5
Uninstalling MultEQ Pro
A dialog with a progress bar will appear as the MultEQ Pro application is
uninstalled. The dialog will disappear once the uninstallation is complete.
Viewing the Setup Guide
An electronic version of the MultEQ Pro Setup Guide is available to view at any
time during the setup.
Add Microphone File to MultEQ Pro
If your company has purchased more than one installer kit, it is highly
recommended you save the microphone calibration file from each of your MultEQ
Pro CDs on each company laptop used for installation. This allows measurement
microphones to be shared and used with any of your laptops.
The “Copied One File” window will be displayed after each microphone calibration
file is successfully copied to your laptop.
It is important to have the correct microphone calibration file with the corresponding
microphone and preamp marked with the matching 5-digit serial number. Each
microphone and preamplifier set is measured by Audyssey and the unique mic
calibration file is stored on the installation CD of the installer kit.
Registered Installers may conveniently retrieve lost calibration files through the
Audyssey Installer Website.
USB to RS232 Driver Installation
Some Audyssey Installer-Ready products require the laptop running the MultEQ
Pro application connect to using the USB to RS232 connector provided in the
Audyssey Installer Kit.
In MultEQ Pro 3.0, and later, the driver to allow you to use the RS232 connector is
located on the MultEQ Pro Installation disc. Microsoft XP or Vista will prompt you if
needed to locate the driver. See Found New Hardware image.
Select the option: Locate and install driver software (recommended).
A new window will launch asking you to insert the disc that came with your USB
Serial Controller. Insert the MultEQ Pro CD. It is advised to not search online for
the driver as it is included on the MultEQ Pro CD and the result may differ greatly.
If a Windows Security warning appears stating that it cannot verify the publisher,
select to, “Install this driver software anyway”.
Once the installation is complete, you will be able to use MultEQ Pro with the
RS232 connection. It is only necessary to perform this procedure once on a PC.
Windows Security
Install this driver anyway
After installing .NET & MultEQ Pro
Copied one file successfully
Locate and install driver software
Search online for driver?
Insert the MultEQ Pro setup disc