User guide

31
Once a grip has been placed, it can be moved by left clicking and holding the mouse button
while dragging with your cursor. The grip may be moved in any direction. This edit
immediately affects the blue and red lines. Grips cannot be moves outside of the valid range
shown on page 40, and cannot be placed too close to another grip.
Spend some time working on placing grips and moving them to get a sense of how to best
build your edit. Create several grips and move them in relation to each other, avoiding sharp
peaks.
Working with Grips
A grip is selected by simply left-clicking on the grip. It will turn green to show it is the selected
(highlighted) grip. With the left mouse button held, you can drag the highlighted grip in any
direction. While holding the CTRL key, you can highlight multiple grips and move them as
one group.
To delete a grip, right click on the highlighted grip or group and select the option to Delete
Points.
To adjust a grip through text entry, right click on the grip and select Enter Point Values. The
frequency cell at the left bottom of the screen becomes highlighted and is ready for you to
manually type in the exact desired frequency you wish the grip to be located at. Press the tab
key to highlight the next cell on the right (or left-click in that cell). Enter the gain you wish to
use (+3.0 dB to -3.0 dB) and press Enter. The grip will move to the new location you entered.
To complete your edit, click the OK key at the bottom right corner of the window. Or to delete
your edits, press the Cancel button adjacent. The Target Curve Editor window will close.