User guide

Select a Zone

Note: The Select a Zone screen only appears if you have assigned more than one

zone to the Sound Equalizer at the Zone Configuration screen, page 21.

The numbers in the Channel column correspond to the channel numbering for the

Sound Equalizer. This may be different than the numbering on the back of the

pre/pro. The information in the Speakers column corresponds to the type of speaker

assigned to each Sound Equalizer channel on the Zone Configuration screen.

Confirm that this information is correct before continuing.

Decide which zone to calibrate by selecting the button next to the Zone. Zones may

be calibrated in any order.

After finishing the calibration for a zone, click the ◄ arrow to return to this screen to

calibrate any remaining zones. See Save Results, page 33.

Room Dimensions

Input the dimensions of the customer’s room by clicking the up/down arrows next to

each data field. Select from English or Metric units (feet or meters).

Note

This screen will need to be completed for each of the zones.

If desired, manually calculate and write down the volume of the room (Area x

Height) to help select an Audyssey target curve later. See Target Sound Options,

page 28).

The information entered at this screen may be stored on the Audyssey Installer

Website account and will not affect filters created or saved to the Sound Equalizer.

Room Dimensions

It should be explained to

customers that if the

layout of the room

changes, a recalibration

will be necessary to

create MultEQ XT filters

that match the room’s

new configuration. This

is because the room’s

configuration influences

the performance of loud-

speakers and therefore,

the frequency response

throughout the room.

Surfaces such as walls,

the ceiling, the floor, and

furniture distort sound

playback throughout the

room.