User's Manual

CONNECTOR

The bodypack uses a mini 3-pin XLR connector for all microphones. Other brands of

microphones can be used with the Audix Performance Series Wireless system; however, it

will be necessary to rewire the microphone connector to a mini 3-pin XLR (f). In this case,

note the following pin conﬁguration:

Pin 3: Signal

Pin 2: Bias (voltage)

Pin 1: Shield

PERFORMANCE TIPS

The best position for a wireless receiver is within line of sight whenever possible.

For more complex set ups, consider extending the antenna range by using the

ANTDA4161 active antennas.

High quality batteries will provide the best results for handheld and bodypack

transmitters. Rechargeable batteries typically have a shorter usage span. It is not possible

to use two sets of transmitters simultaneously on the same frequency. It will not work.

Each time a scan and sync is performed, the transmitter will always be tuned to the current

frequency on the receiver. When using dual systems, always scan and sync each channel

independently from one another.

ANTENNAS

Both antennas must be installed in order for the diversity function to work properly.

Always attach both antennas to the receiver.

MULTIPLE SYSTEMS

It is fairly straightforward to get up to 24 channels of wireless to work simultaneously. This

is done using a standard Scan and Sync method, adding one system. The systems will stay

in the same Group until the group maxes out its channel selection. At this point, it may be

necessary to manually select a diﬀerent Group for additional pre-coordinated channels. More

experienced users may use the Tune mode to manually set up their frequency selections.