User Manual

SPECIFICATIONS:
www.audixusa.com Call: 503-682-6933 Fax: [phone]
Audix Corporation 9400 SW Barber Street, Wilsonville, OR 97070
Transducer Type Dynamic
Frequency Response 40 Hz - 16 kHz
Polar Pattern Hypercardioid
Output Impedance 580 ohms
Sensitivity 0.6 mV / Pa @ 80 Hz
Capsule Technology LM Type A
Off Axis Rejection >23 dB
Maximum SPL ≥140 dB
Power Requirements None
Connector 3 pin gold plated male
XLR connector
Polarity Positive voltage on pin
2 relative to pin 3 of
output XLR connector
Housing / Finish Cast zinc alloy /
Black coat
Weight 311 g / 11 ounces
Length 121 mm / 4.76 inches
FREQUENCY / POLARS:
SERVICE AND WARRANTY:
This microphone is under warranty for
a period of 3 years from any and all
manufacturing defects. Should your
microphone fail in any way, please con-
tact the Audix Service department at
503-682-6933. A Return Authorization
number is required before returning
any products.
CARE AND MAINTENANCE:
The f6 is manufactured to exacting specs with
roadworthy construction. However, the capsule
is highly sensitive and should be handled with
care. Avoid extreme temperatures and be sure
to store your microphone in the pouch provided
when not in use. Moisture of any kind can
adversely affect the sound and performance of
your microphone.
To register your
microphone, please visit
www.audixusa.com
***All specications subject to change without notice.
OPERATION:
The f6 is a low impedance microphone and should be plugged into a “mic level” of
your console, mixer, or recording device. Please note that your microphone does not
require phantom power and will not be effected in any way by phantom power should
it be running simultaneously while the microphone is in operation. Avoid plugging or
unplugging the microphone from the PA system unless the channel is muted or the
volume of the system turned down. Failure to do so may result in a loud “popping”
noise which could seriously damage the speakers in the PA system.
ARCHITECTS AND ENGINEERS SPECIFICATIONS:
The microphone shall be of the dynamic type operating on the moving coil principle
and the capsule shall be LM Type A. The polar pattern of the microphone shall be
hypercardioid. The nominal output impedance shall be 580 ohms at 1 kHz.The
microphone shall have a sensitivity of 0.6 mV / Pa at 1 kHz and will handle a sound
pressure level of ≥140 dB. The microphone body shall be cast of zinc alloy metal
and the grill cap shall be steel wire mesh. The overall dimensions shall be 21 mm in
diameter at the base, 58 mm in diameter at the widest point and 121 mm in length. The
microphone shall be the Audix f6.
USER TIPS:
The f6 is designed with low output in order to compensate for instruments having
very high sound pressure levels. For kick drums, as a general rule, start with the
mic positioned centered inside the middle of the drum pointed towards the beater. For
more attack, and less bass boom, move the mic closer to the beater. For less attack
and more bass, move the mic further away from the beater. For kick drums without
hole in front head, place the f6 a few inches from the head for a large dynamic sound.
For toms, position the mic 2 inches from the head and point towards the center of the
drum. For bass cabinets, position the mic 90 degrees to the grill cloth and 1-2 inches
inside the edge of the speaker.
*Further miking techniques may be found on our website at www.audixusa.com
DIMENSIONS (mm):
f6