Specifications

45
Digital domain
ADVANCED MANUAL / TH quattro
PRESS PRESS UP TO PRESS PRESS
UP TO
0
5
8
7
6 4
3
2
19
IN A IN B OUT A
DIGITAL AUDIODC OUT CONTROL BUS REM
OUTINADRS
IN
OPTICAL
GND
+15
-15
OUT - AD Link - IN
L R L R L R
1 - AC Link - 2
MIN
Front Panel
How to adjust the PRE OUT analog output
As already said, the AMP ID can also be assigned to the PRE OUT output, but not only to it. Through the AC
Net software also the PRE OUT sensitivity can be adjusted to align the gain of the amplifier connected to that
output, thus adapting sensitivity according to the system general volume increase and decrease.
The procedure to perform this operation is the following:
1- Connect the (non-TH) amplifier to the PRE output.
2- Assign the ID - Preout.
3- Set the non-TH amplifier sensitivity to the minimum.
4- Through the AC Net slider, increase the output sensitivity until you get the desired volume.
5- Should it not be enough, increase the non-TH amplifier input sensitivity