Owner`s manual

55
OWNER’S MANUAL / TH uno
Digital domainGeneral
ASC - Amplifier Status Controller
Info and Alert sentences
Autoreset
Event’s alert
Event’s alert
Event’s alert
Event’s alert
Autoreset
Autoreset
Amp off
Amp in muting
Amp in default
Amp in muting
5
6
7
9
11
8
10
4
2
1
3
What the TH
is doing
What the display
is showing
What it means
These messages appear also on the DRC display.
The DRC will display amplifier name and ADRS on the first row.
The previously found connection with DRC has been lost. This information is
also displayed when the amplifier is on and the DRC gets disconnected.
Volume goes back to 0 dB (the set sensitivity is not modified). Balance and
Fader are set back to their centre position (0). The Sub volume is set back to
0 dB. The ANALOG input is automatically selected.
MONO-STEREO switch position is different from the original position
acquired during the Amplifier Setup (STEREO).
You have to access to the ASC and at least set the AMP ID.
MONO-STEREO switch position is different from the original position
acquired during the Amplifier Setup (MONO).
You have to access to the ASC and at least set the AMP ID.
General protection.
The amplifier will try to restart 5 times.
Contact Audison Technical Support.
Overload protection.
Check speaker load. This message
is displayed when an overload occurs.
Rare overload occurs. Check speaker load.
This message is displayed when an overload has already
occurred but the amplifier restarted.
Output is reaching distortion threshold. The information is immediate and
stays displayed only while distortion is still present.
Thermal protection. Check environmental temperature
and/or use a low bias Dual Power setting.
Rare thermal protection occurs. Check environmental temperature
and/or use a low bias Dual Power setting.
Contact with ground. Stop listening and check speaker cables.
Rare contact with ground occurs.
Stop listening and check speaker cables.
130.com.ua
Autogood products internet store http://130.com.ua