Owner`s manual

45
OWNER’S MANUAL / TH uno
Digital domain
0
5
8
7
64
3
2
1
9
TH uno TH uno
PRESS PRESS
TH unoTH uno
UP TO PRESS PRESSUP TO
MIN
Front Panel
How to adjust the PRE OUT analog output
As already said, the AMP ID can also be assigned to the PRE OUT output, but not only to it. Through the
ACNet software also the PRE OUT sensitivity can be adjusted to align the gain of the amplifier connected to
that output, thus adapting sensitivity according to the system general volume increase and decrease.
The procedure to perform this operation is the following:
1- Connect the (non-TH) amplifier to the PRE output.
2- Assign the ID - Preout.
3- Set the non-TH amplifier sensitivity to the minimum.
4- Through the AC Net slider, increase the output sensitivity until you get the desired volume.
5- Should it not be enough, increase the non-TH amplifier input sensitivity
130.com.ua
Autogood products internet store http://130.com.ua