Owner`s manual

42
OWNER’S MANUAL / TH uno
Digital domain
0
5
8
7
64
3
2
1
9
REM Out
Digital (Optical) Out
REM In
Pre Out
Pre In
BRIDGE 0 180
PHASE
MASTER
CHAIN
PUSH
LEVEL
0.3 ÷ 1.2V RMS
1.2 ÷ 4.8V RMS
Hi :
Lo :
TH uno
Front Panel
TH configured in MASTER mode
Input: IN R or IN L Analog/Digital Optical S/P DIF
Pre Out: Analog (=IN R or IN L)
Power Output: In Analog: Mono (=IN R or IN L)
In Digital: Mono (=MIX L+R)
How to connect an analog and a digital source in a
system featuring other non-TH amplifiers
In this case the DRC is REQUIRED in order to:
- Adjust general volume
- Select the optical input
PRE OUT:
See page 44, to check how to manage it.
Setting changed
See page 34
In order to take advantage of
Volume control, Balance,
Fader and Sub through the
DRC also on the PRE output,
the AMP ID - Preout needs to
be set to the ASC Setup.
130.com.ua
Autogood products internet store http://130.com.ua