Owner`s manual

ManualsBrandsAudison ManualsAutomotiveLR 72

OWNER’S MANUAL / TH uno

Digital domain

DOWN

ENTER ENTER

BRIDGE 0 180

PHASE

MASTER

CHAIN

PUSH

LEVEL

0.3 ÷ 1.2V RMS

1.2 ÷ 4.8V RMS

Hi :

Lo :

TH uno

ASC - Amplifier Status Controller

Setup Amplifier: Main Input

How to change: Main Input

Valore di Default

The first step to set the amplifier up is to select the main input the TH will use to get the signal. As soon as you

turn the amplifier on, the PRE analog input is selected by default. By changing this entry the user can also take

advantage of the other operational modes. From next time you turn the TH on, it will use the last selected entry.

If another input is used, the DRC is required. In that case, if for any reasons it is disconnected, all the setup

settings and low level controls will reset back to the default settings, unless the DRC is re-connected, in which

case they restore. (See page 35)

PRESS ENTER TO CONFIRM YOUR

SELECTION AND MOVE TO THE

NEXT SETUP

When this entry is selected, the amplifier can exclusively use the

pre-amplified input.

In multi-amplified systems, in order to cascade other amplifiers when using

the analog input, the Pre Out analog output MUST be used.

In this case, the amplifier can use the IN OPTICAL digital input or the

pre-amplified input. You can select either input only through the DRC.

In multi-amplified systems, select this entry only on the first chain TH

amplifier, which is the one physically receiving the signal from the digital

source.

In this case, the amplifier receives the input signal from another TH amplifier

through the AD Link digital connection.

In multi-amplified systems where both the analog and digital inputs are

connected, when moving from a source to another through the DRC, each

amplifier will automatically change input.

Select this entry when the amplifier is connected through the AD Link to a

system managed by an Audison external processor (such as the Bit One).

This entry gets active and is displayed only when the processor is

connected.

If for any reason the processor is disconnected with the amplifier on, the

ASC will go back to the default settings.

130.com.ua

Autogood products internet store http://130.com.ua