Owner`s manual

30
OWNER’S MANUAL / TH uno
Classic domain
12 V
SPEAKER A SPEAKER B
+
-
+
-
POWER
+
-
+
CAP
12 V
0 5
8 7
64
3 2
1
9
SS1 SW1 or SW2
Pre Out
DRC (Optional use)
Analog Source
PRE OUTSPEAKER
mono
mono
LEFT
PRE IN PRE IN PRE OUT
mono
SPEAKER
RIGHT
Rem IN
Rem OUT
Tweeter
Woofer
Subwoofer
Passive Crossover
Hz
USB / AC Link Converter
ACNet (Optional use)
Front Panel Rear Panel
BRIDGE 0 180
PHASE
MASTER CHAIN
PUSH
LEVEL
0.3 ÷ 1.2V RMS 1.2 ÷ 4.8V RMS
Hi :
Lo :
TH uno
Example: Two Way + Sub, bi-amplified,
with and without TH amplifiers.
Analog Input
In order to build a
Standard System:
You have to follow same steps as
per the above example. The only
difference is that TH uno
becomes the audio chain first
amplifier, thus being able to
manage the whole system;
In order to add DRC:
7- Set ADRS on the Front Panel;
8- Set the Amp ID in the ASC
Setup Amplifier as Sub.
9- Set the ID Preout as Front, to
let DRC adjust general Volume,
Balance, Fader as well as Sub
Volume.
In order to adjust the
system through the
ACNet:
Once the above listed steps have
been performed, the Software
will temporarily bypass the DRC
in order to manage in a more
direct and easier way all of the
system functions.
REMARK: On ASC Dual Power
and Runtime Monitor will anyway
stay active (by default) and
ready for changes (see page 47
and following pages).
130.com.ua
Autogood products internet store http://130.com.ua