Owner`s manual

28
OWNER’S MANUAL / TH uno
Classic domain
0 5
8 7
64
3 2
1
9
12 V
SPEAKER A SPEAKER B
+
-
+
-
POWER
+
-
+
CAP
12 V
Front Panel Rear Panel
Subwoofer
SS1 SW1 or SW2
USB / AC Link Converter
ACNet (Optional use)
BRIDGE 0 180
PHASE
MASTER CHAIN
PUSH
LEVEL
0.3 ÷ 1.2V RMS 1.2 ÷ 4.8V RMS
Hi :
Lo :
TH uno
0 5
8 7
64
3 2
1
9
Source
Front Panel Rear Panel
REM Out
DRC (Optional use)
Tweeter
Woofer
Pre Out
SW1 or SW2
Hz
Passive Crossover
RIGHT
CHANNEL
LEFT
CHANNEL
Hz
Passive Crossover
Example: Two Way + Sub, bi-amplified, TH amplifier
Analog Input
In order to build
a Standard
System:
You have to follow
same steps as per
the above
example. The only difference is
for point 4, the second TH is a
TH uno (mono);
In order to add DRC to
the System you also
need to:
7-Give the Front Panel ADRS of
each of the two amplifiers a
different setting (Example: 1
and 2);
8- Configure the Amp ID on the
ASC Setup Amplifier of the two
amplifiers by setting TH (1) as
Front and TH (2) as Sub;
9- Set the TH (1) ID Preout as
TH Amp, to let DRC adjust
general Volume, Balance,
Fader as well as Sub Volume.
In order to adjust the
system through the
ACNet:
Once the steps 1, 2,
3, 4, 5 and 7 have
been performed, the
Software will
temporarily bypass
the DRC in order to
manage in a more
direct and easier
way all of the system
functions.
REMARK:
On ASC Dual Power
and Runtime Monitor
will anyway stay
active (by default)
and ready for
changes (see page
47 and following
pages).
130.com.ua
Autogood products internet store http://130.com.ua