Owner`s manual

27
OWNER’S MANUAL / TH uno
Classic domain
0 5
8 7
64
3 2
1
9
12 V
SPEAKER A SPEAKER B
+
-
+
-
POWER
+
-
+
CAP
12 V
Source
Front Panel Rear Panel
REM Out
DRC (Optional use)
Pre Out
USB / AC Link Converter
AC/Net (Optional use)
BRIDGE 0 180
PHASE
MASTER CHAIN
PUSH
LEVEL
0.3 ÷ 1.2V RMS 1.2 ÷ 4.8V RMS
Hi :
Lo :
TH uno
Subwoofer
SS1 SW1 or SW2
Example: TH amplifier on Subwoofer
Analog Input
In order to build a Standard System
you have to:
1- Insert the TH-MXR.1 board with its relative
filter module;
2- Connect power supply;
3- Connect the subwoofer;
4- Connect signal inputs and remote turn on;
5- Select working mode on the Input
Controls Panel;
6- Adjust sensitivity on the Input Controls
Panel “LEVEL”;
In order to add DRC to the System
you also need to:
7- Set ADRS on the Front Panel (in position 1
for instance);
8- Set Amp ID (on SUBWOOFER for
instance) in the ASC Setup Amplifier; this
way DRC will be enabled to adjust general
Volume, Balance and Fader.
In order to adjust the system
through the ACNet:
In questo sistema è necessario eseguire i
punti 1, 2, 3, 4, 5 e 7.
Il Software escluderà temporaneamente la
funzionalità del DRC per poter gestire tutte
le funzioni dell’amplificatore durante le fasi
di taratura e modifica, compresa la
regolazione della sensibilità d’ingresso con
tanto di rivelatore di picco.
REMARK:
On ASC Dual Power and Runtime Monitor
will anyway stay active (by default) and
ready for changes (see page 47 and
following pages).
130.com.ua
Autogood products internet store http://130.com.ua