Users Manual

31
USER'S MANUAL
8. Auto Input Switch
The automatic volume control for the
auxiliary source (Aux - Optical 1/2) can
be activated through the Head Unit
volume control, if it is provided with an
AUX input
(see sec. 5.4.3, 5.6.1; 8.3.5).
If the car HEAD UNIT does not have
an AUX analog input, connect a USB
memory (or SD Card) to the USB reader
of your audio source as shown to the
side. The USB/SD device must contain
the mp3 format le available in the RVA
TONE folder located inside the Setup CD
(these les can also be downloaded from
the Audison website).
Please note that the storage device must
only contain this le and no other les.
If you use the USB memory to activate
the switching via the RVA function, simply select the USB (SD) or Master input.
- Press BACK to go back to the previous step.
- Press NEXT to continue with the conguration.
- Press SKIP to bypass the procedure.
Follow the instructions listed below:
1) Use of the Head Unit AUX input:
- connect the Head Unit AUX IN inputs
to the RVA connector of the
bit One HD Virtuoso using the
appropriate cable.
- select the source AUX IN input
(Head Unit).
- set the source volume to the
maximum undistorted level.
2) Use of the Head Unit USB input:
- Press NEXT and then adjust the RVA
function settings as per
section 8.3.5.
At the end of the procedure:
- Press BACK to go back to the
previous step.
- Press NEXT to go ahead with the
conguration.
- Press CANCEL to exit.
7