Specifications

13
Elettromedia
62018 Potenza Picena (MC) Italy
T [phone] - F [phone]
www.elettromedia.it
All specications subject to change without notice_16.D
www.audison.eu
Audio DSP and
converters
Analog Devices DSP (ADSP-21489), 32 bit floating-point Sharc series (450 MHz clock). Cirrus Logic (CS5368 8ch and CS4365 6ch) A/D and D/A
converters (24 bit/192 kHz) providing very high level performance
Inputs 12 independent high-level channels (signal-summing) or 6 independent analog low-level channels
2 analog low-level stereo auxiliary inputs
2 optical digital inputs (TOSLINK)
Memory 8 Preset separately managed and recalled from the DRC MP
Outputs 13 independent low-level analog channels and 2 AD Link outputs (13 independent digital audio channels to be connected through two CAT 5.S LAN
cables for use with AD Link provided ampliers)
Turn on Controls ART™, Automatic Remote turn On/Off for high level inputs through the DRC MP
Conguration Guided procedure for the calibration and “signal routing” of the input channels to the output channels based on type and number of inputs,
loudspeakers and ampliers, for the system setup to be developed
Signal summing,
De-Equalization and
Delay compensation
Automatic algorithms dedicated to the reconstruction of a stereo signal from a multi-channel signal and to ne-tune the signal in advanced OEM
systems: time delay compensation (De-Ta); sum of multi-amplied and limited bandwidth signals; signal de-equalization (De-Eq)
In/Out Volume Input sensitivity automatically adjusted for the main inputs (Wizard with CD and DVD Test)
Manual input sensitivity adjustment for auxiliary inputs (SW)
Independent level control for each output channel for system ne-tuning (-40 ÷ 0 dB)
Dynamic Equalizer Automatic system for the dynamic equalization between low and high listening levels, to be selected by the user via DRC MP
Equalizers Four 5-poles parametric FIR type equalizers, one for each source
Thirteen 11-poles parametric IIR equalizers, one for each output channel
One 5-poles parametric FIR type main equalizer
Bass Boost Low frequencies enhancement based on parametric equalizer, bound to the Woofer and Sub sections, to be set up by the user and selectable via DRC MP
Crossover lter Filter type: Hi-Pass, Lo-Pass, Band-Pass, Full Range
Cut-off frequency: 70 steps available from 10 ÷ 20 kHz
Cut-off slope: 6 ÷ 48 dB Oct.
Alignments: Linkwitz, Butterworth, Bessel
Mute/Solo: for each output (On/Off)
Phase: for each output (0°/180°)
Time alignment Procedure to set up the time delays on the real distances between the loudspeakers and the listening point (0÷22 ms max). The system also provides
for a manual ne-tuning in steps of 0.01 ms
Auto restart Auto restart in case of DSP fault
DRC MP Control: Master Volume (-60 ÷ 0 dB), Subwoofer Volume (-12 ÷ 0 dB), Balance, Fader; Inputs selection; Management of the pre-sets stored;
Bass Boost function turn on/off
PC Connection 1 micro USB connector (1.1/2.0/ 3.0 compatible) to connect to the PC
bit One HD software Windows-based software (32/64 bit): Windows XP, Vista, 7, 8, 8.1, 10 available in “Standard” or “Expert” mode
Minimum resolution: 800 x 600
bit One HD
High Denition
Signal Processor