Installation guide

ADVANCED MANUAL / bit Ten D /

Important Remark

1. The steps of this upgrade must be performed strictly FOLLOWING THE SEQUENCE here, exactly as per the

chronological order indicated in this document.

2. The firmware upgrade should be performed with care, following the warnings listed in the DRC firmware

upgrade section of this document, to avoid damaging the product.

3. In order for the DRC to be upgraded, it must be connected to a bit Ten D.

Preliminary steps:

1. Create a new folder (named for example: DRC upgrade) on the PC Desktop, or wherever you prefer.

2. Download from http://update.audison.eu the zipped folder called, for example,

“DRC_upgrade_firmware V1 90.zip” and save it in the folder you have just created.

3. Open the zipped folder “DRC_upgrade_firmware_V1_90.zip” using suitable software

(for example WinZip or “Compressed folders” Windows utility if available in your PC),

and save the file you find inside it (“DRC_upgrade_firmware_V1.90.exe”).

Remark: The firmware update procedure requires particular attention. So, it must be performed under the best possible

conditions: if the firmware upgrade is launched but prematurely interrupted (for example because the PC locks up,

or a supply voltage drop occurs to the bit Ten D, or the USB accidentally disconnects during the firmware upgrade),

you might need to contact our Customer Service for further support as DRC reprogramming may be necessary.

1. Connect the PC to the audio system where the DRC is

installed (bit Ten D) using a USB cable.

2. Supply power and turn on the bit Ten D, so that the DRC is on.

3. Launch the program “DRC_upgrade_V1_90.exe”.

4. Select bit Ten D and then click OK.

- disable anti-virus software.

Click YES.

5. The PC is synchronized with the DRC. Then click on:

- DRC Upgrade Vxxx to update the device.

- Quit: to exit.

6. A warning pop-up dialog box will appear,

indicating that you have to:

- close all running programs;

- disable any screen saver;

- disable energy saving modes;

- disable any anti-virus software.

Click YES.

7. Wait until the upgrade procedure is complete.

8. A pop-up dialog box showing the message Upgrade completed

will appear. Click OK.

9. Click Quit to close the DRC Upgrade Software.

10.4 DRC FIRMWARE UPGRADE

If, when launching the bit Ten D PC software, the “bit Ten D Warning” window pops up, it means that the DRC

Firmware needs to be updated.