Installation guide

ADVANCED MANUAL / bit Ten D /
34
The bit Ten D has five crossover filters, one per each output channel.
Each filter allows you to set the parameters of a single output channel.
1.
Xover L/R Link: modifications applied to one of the channels (right or left)
will also automatically be applied to the other one. To do so, click on the blue
led which will light up.
Xover L/R Link affects all Filter Settings adjustments except
Set Distance (Delay).
2. Invert Phase: inverts the phase of the channel under examination by 180°.
This can be done by selecting the green light which will turn on.
This can be useful to solve phase alignment problems among
the different filtered channels.
3. Filter Type: lets you select the different types of filters that can be assigned to channels:
- Full Range
- Low Pass
- High Pass
- Band Pass
In STANDARD mode:
According to the speaker or speaker system selected during
setup, suitable filter types will be available.
E.g. for the Front Woofer only Low Pass or Band Pass will be
available. For the Front Mid-Hi only High Pass and Band Pass
will be available, etc.
In EXPERT mode:
Every speaker system selected has every filter type available.
WARNING: In EXPERT mode, pay due attention to the filter selection.
Speakers have mechanical limits that must not be exceeded,
otherwise they could lead to permanent damage. When you
select a filter, some optimized cut-off frequencies are set by
default to avoid breaking the speakers.
E.g. if you select Low Pass for a tweeter, the default frequency is
suitable for a woofer but not for the tweeter, which may be damaged.
4. Filter Model: lets you select the type of filter to be applied.
- Linkwitz (default)
- Butterworth
When launching the bit Ten D software, it suggests Linkwitz as the standard
filter model for the speaker or speaker group connected to the corresponding
channel. To apply the opposite (Left / Right), turn the Xover L/R Link on.
If you modify the model to Butterworth, the change will be applied to both.
8.10 FILTER SETTINGS
8
7
STANDARD MODE
Full Range Low Pass High Pass Band Pass
Tweeter x x
Midrange x
Woofer x x
Mid-Hi x x
Subwoofer x x
Full x x x x
FILTER
TYPE ->
EXPERT MODE
Full Range Low Pass High Pass Band Pass
Tweeter x x x x
Midrange x x x x
Woofer x x x x
Mid-Hi x x x x
Subwoofer x x x x
Full x x x x
FILTER
TYPE ->
12
3
4