Service manual

09/09 Rev. 5.02-02 SERVICE MANUAL Service Electronics

AP 4.4 – AP 5.4 – AP 7.t

Setting the Interface Parameters

With an I/O board mounted, the following additional menus appear in the prin-

ter menu:

• INTERF. PARAM. > COM2 PORT

Contains all parameters required to configure the serial interface.

• I/O BOARD

Contains all parameters required to configure the signal interface.

P For detailed parameter descriptions see topic section Info-printouts &

Parameters.

Menu Parameter Setting

INTERF. PARAM. >

COM2 PORT

Baud rate 9600

No. of data bits 8

Parity None

Stop Bits 1

Data synch. RTS/CTS

Serial Port Mode RS 232

SYSTEM PARAMETER External signal Singlestart

Reprint function Enabled

I/O BOARD Start delay 0.0 mm

Start print mode Pulse falling

Reprint signal Enabled

Feed Standard

Pause input Standard

Error output Print error

Error polarity Level low active

Status output Print job ready

Status polarity Level low active

End print mode Mode3 low pulse

[Tab. 5] Recommended parameter default settings.