Owner`s manual

Bel_3re perlk)rming Ihe following operations, pless
_SIRIUS
• All Channel Search mode
1 Press @SEARCH MODE (or _SRCH
MODE) repeatedly to select "ALL CH
SEARCH".
2 Press@PRESET/TUNING/CH <1/1> (or
@PRESET/CH A / V) repeatedly to search
for a channel within all channels.
• Yoll cm sealch ioi a channel (plickly by pressing and holding
@PRESET/TUNING/OH <_ / t_
1o_ @PRESET/CH A /_71
• You can skip channels to tl/_"previous or ll_'xt c re'gory b?_
plessing @CATEGORY 0_r @A-E/CAT. <_ / E> I
• Category Search mode
1 Press @SEARCH MODE (or _SRCH
MODE) repeatedly to select "CAT SEARCH".
2 Press@CATEGORY([e-mail].<_I_>)
repeatedly to change the channel category.
3 Press@PRESET/TUNING/CH <lit:> (or
@PRESET/CH A / V) repeatedly to search
for a channel within the selected channel
category.
"Am can search fi)r a channel quickly by presshlg md hokling
@PRESET/TUNING/CH <_/c> (or @PRESET/CH A/V)
This uni_ skips the channels _hen tl/is unit is All Channel Search
mode ol Ca[egoQ Search mode in tile lollowing cases (il is not
malJunction ol this unh):
Ihe channel is locked (see page 54)
dae channel is out ol service
you do not subscribe to the channel
• Preset Search mode
Prior to selecting n pl_set channel in the Preset Seurch
mode, you must preset S[RIUS channels. For details, see
"Setting the SIRIUS Satellite Radio TM preset channels" on
page 54.
1 Press @SEARCH MODE (or OSRCH
MODE) repeatedly to select "PRESET
SEARCH",
2 Press@CATEGORY(or@A.E/CAT. <31r:>)
repeatedly to change the preset channel
group (A to El.
3 Press@PRESET/TUNING/CH <_/_> (or
@PRESET/CH A / V) repeatedly to change
the preset channel number (1 to 8).
"_ixl can also select the preset channel number directly by
pressing Ihe numelic buttons (1 to 8) (_)1
• Direct Number Access mode
1 Press _SRCH MODE on the remote control
repeatedly to select "ALL CH SEARCH" or
"CAT SEARCH",
2 Press the numeric buttons (_D) to enter the
desired three-digit channel number,
For example, to enter the nmnher 123, press the
numeric buttons (v_))as shown below.
%*%
• To display Ille SIRIUS Radio ID (SID) number displayed ill the
fi'ont panel display, select channel "0"
• To enler a one-digit or Iwo-digil channel number, press the
numeric buttons (@) on the remote control and then press
{_ENT to confirm the input number
• Instead of pr_-ssing @ENT Io tune inn) tile channel
immediately, you can _ait a I_w seconds until Ihis unit confirms
[he eRler_.'d chaRilel i1umber
• Pressing a breton other than the numeric buttons (@/or {_}ENT
cancels the Direct Nmnber Access mode plocedur,"
• If the selecled channel is locke& "PIN: " appears in tile
fi'ont panel display. Enler the Ik)ur_digit Pmenlal Lock code
number by usilig the numeric buttolis 1@) or pl'cs_ @ENT Io
cancel
|
53 En