Instruction manual

– 20 –
(2) Lug Mounting
Pass a bolt through the lug mounting hole (0.25” diameter) on
the rear cover and tighten securely. When mounting by this
method, if the tightening force is insufficient, the gauge may be
tilted towards the bottom about the ears. Take care that this does
not occur. Use flat and spring washers on both sides as shown in
the figure below.
The lug can be rotated 90° by removing the screws on the rear
cover.
7. MOUNTING METHOD
(1) Mounting By Grasping the Stem
The diameter of the stem is 0.375/0.374”, enabling mounting on
either an optional gauge stand (ST-022, ST-044B with option) or
a stand which has been prepared by the user as shown in the
figure below.
Care should be taken not to apply excessive force to the stem.

Tightening screw
t=0.63
0"
0.376/0.375"DIA